Forum > Exhaust, Fuel Management, and Performance

Muzzy Install

(1/1)

lyricalslangbang:
I got my muzzy, PC III, and K&N today and couldn't wait to pop it on.  I got it all hooked up and mapped, but the Muzzy mid pipe doesn't want to go down all the way. 

I tried spinning it and pushing the hell out of it, but it doesn't go far enough down for the spring to catch?  Any tips or am do I just have the upper body strength of a fetus?

Once all this is pretty I'm taking it to get dyno'd. I had it dyno'd two days ago at 98HP and 58 LBS of tourque, not bad for 15,000 miles, but I'm curious what this will add.

Thanks for the help.

Mike L:
Does it not go over the header as far as the mid-pipe? If so, how much too short?

Or are you talking about the muffler over the mid-pipe (that's where the springs are on the Scorpion my son is running)?

In either case, if it is hitting a hard stop, that's as far as it goes unless you trim something.  If it is a matter of running out of clearance, you might be able to have a muffler shop neck down the forward end of your mid-pipe a bit till it fits.

lyricalslangbang:
The mid pipe is just not going down far enough on the header, by about 1/2 or 1/4 inch.  Everything lines up alright, there really wasn't a squeeze bolting the muffler on.  I rode it to work today just fine, no exhaust leak.  When I have it tuned and dyno'd, I'll just have them look at it.

Navigation

[0] Message Index